KERN PES Series - 12.4.3. Numeric entering of 2 limits

PES/PEJ-BA-e-1316
66
12.4.3. Numeric entering of 2 limits
Operation
Display
1. Activate tolerance weighing function
[ ] or [ ] (see chap. 7).
2. Actuate required parameter selection
or
until
[ ] or [ ] is displayed;
more settings of your choice (see chap.
12.3) are carried out in the same way
Parameter selection for 2 limiting points:
Parameter selection for absolute value:
3. Leave function menu
g
The balance is now in tolerance weigh-
ing mode; the tolerance marker (
)
appears
4. Entering limiting values:
Press for about 4 seconds, until
[ ] is displayed, then
release
The last saved limiting value is displayed
flashing