Keysight Technologies 11713D - Page 71

Remote Operations 6
Keysight 11713D/E Operating and Service Manual 71
Related Commands
CONFigure[:BANK1]/CONFigure:BANK2
CONFigure[:BANK1]:TTL/CONFigure:BANK2:TTL
CONFigure[:BANK1]:PULSe:DRIVe
CONFigure:BANK2:PULSe:DRIVe
CONFigure[:BANK1]:PULSe:WIDTh
CONFigure:BANK2:PULSe:WIDTh
ATTenuator[:BANK1]:X/ATTenuator[:BANK1]:Y
ATTenuator:BANK2:X/ATTenuator:BANK2:Y
CONFigure[:BANK1]/CONFigure:BANK2
Sets and returns the supply voltage for each bank.
CONFigure[:BANK1] <voltage>
CONFigure:BANK2 <voltage>
Examples
To set the supply voltage for bank 1 to P24v:
CONF:BANK1 P24v
To query the set supply voltage for bank 1 and bank 2:
CONFigure:BANK1?
CONFigure:BANK2?
Related Commands
:CONFigure[:BANK1]:X/:CONFigure[:BANK1]:Y
:CONFigure:BANK2:X/:CONFigure:BANK2:Y
CONFigure[:BANK1]:TTL/CONFigure:BANK2:TTL
CONFigure[:BANK1]:PULSe:DRIVe
CONFigure:BANK2:PULSe:DRIVe
CONFigure[:BANK1]:PULSe:WIDTh
CONFigure:BANK2:PULSe:WIDTh
ATTenuator[:BANK1]:X/ATTenuator[:BANK1]:Y
ATTenuator:BANK2:X/ATTenuator:BANK2:Y
Query? Yes
Set? Yes
Set/Return Parameters OFF|P5v|P15v|P24v|USER
Minimum n/a
Maximum n/a
Units None