SYSTem Subsystem
Command/Query Description
SYSTem:BEEPer[:IMMediate] Issues a single beep.
SYSTem:BEEPer:KCLick ON|1|OFF|0
SYSTem:BEEPer:KCLick?
Disables or enables the click tone heard when you press a front-panel key.
SYSTem:BEEPer:STATe ON|1|OFF|0
SYSTem:BEEPer:STATe?
Disables or enables the beep heard when an error is generated.
SYSTem:COMMunicate:RLSTate
LOCal|REMote|RWLock
SYSTem :COMMunicate:RLSTate?
Configures the remote/local/lockout state of the instrument.
SYSTem:ERRor[:NEXT]? Reads and clears one error from the error queue.
SYSTem:ERRor:COUNt? Returns the number of errors in the error queue.
SYSTem:SECurity:IMMediate Clears all user memory (including stored states) and reboots the instrument in
the *RST state.
SYSTem:SSAVer[:STATe] ON|1|OFF|0
SYSTem:SSAVer[:STATe]?
Enables or disables the screen saver.
SYSTem:SSAVer:DELay <seconds>|MINim-
um|MAXimum
SYSTem:SSAVer:DELay? [MINimum|MAXimum]
Sets the delay time for screen saver activation.
SYSTem:SSAVer:RWAKeup ON|1|OFF|0
SYSTem:SSAVer:RWAKeup?
Enables or disables remote screen saver wake-up.
SYSTem:VERSion? Returns the version of SCPI that the instrument uses.
TRIGger Subsystem
Command/Query Description
TRIGger:ACQuire[:IMMediate] Sends a software trigger to the ACQuire subsystem.
TRIGger:ACQuire:SOURce IMMediate|BUS
TRIGger:ACQuire:SOURce?
Sets the trigger source that starts the measurement after
INIT:ACQ.
TRIGger:SYNChronize:SOURce IMMediate|PHASe
TRIGger:SYNChronize:SOURce?
Sets the output-on phase control when OUTPut ON is sent.
TRIGger:SYNChronize:PHASe[:ON] <value>|MINim-
um|MAXimum
TRIGger:SYNChronize:PHASe? [MINimum|MAXimum]
Sets the phase angle of the output-on phase control in degrees.
TRIGger:TRANsient[:IMMediate] Triggers the TRANsient subsystem.
TRIGger:TRANsient:SOURce IMMediate|BUS
TRIGger:TRANsient:SOURce?
Sets the trigger source for changing the setting value after
INIT:TRAN.
Keysight AC6800B Series Operating and Service Guide 113
3îîSCPI Programming Reference
To Next Page
Loading...