Error Code Error Text
+133 Operation conflicts with OUTPUT COUPLE setting
+134 Operation conflicts with AUTO RANGE
+155 Operation conflicts with EXT-AC or EXT-DC program source
+140 LOW RANGE conflicts with existing VOLT[:IMM] setting
+141 LOW RANGE conflicts with existing VOLT:TRIG setting
+142 LOW RANGE conflicts with existing VOLT:OFFS[:IMM] setting
+143 LOW RANGE conflicts with existing VOLT:OFFS:TRIG setting
+150 Overlaid peak value of AC (IMM) and DC (IMM) components is too large
+151 Overlaid peak value of AC (IMM) and DC (TRIG) components is too large
+152 Overlaid peak value of AC (TRIG) and DC (IMM) components is too large
+153 Overlaid peak value of AC (TRIG) and DC (TRIG) components is too large
+160 IMM setting is out of range
+161 TRIG setting is out of range
+162 Overlaid peak value with existing AC (IMM) component is too large
+163 Overlaid peak value with existing AC (TRIG) component is too large
+164 Overlaid peak value with existing DC (IMM) component is too large
+165 Overlaid peak value with existing DC (TRIG) component is too large
+166 LIM:LOW setting is out of range
+167 LIM:UPP setting is out of range
+168 IMM setting value and soft-limits conflict with LOWER<=VALUE<=UPPER condition
+169 TRIG setting value and soft-limits conflict with LOWER<=VALUE<=UPPER condition
+302 Option not installed
+309 Cannot initiate, voltage and frequency in fixed mode
+901 HW failure (DSP DETECT state)
+902 HW failure (DSP VCC state)
+903 HW failure (DSP INPUT state)
+904 HW failure (DSP Communication Failure)
3îîSCPI Programming Reference
168 Keysight AC6800B Series Operating and Service Guide
To Next Page
Loading...