4- 36 Keysight B1500A User’s Guide, Edition 14
Specifications
Hardware
The V Monitor terminal outputs a buffered signal equal to 1/10 of the Output
terminal voltage (into a 50 load).
• WGFMU to RSU cable length
The WGFMU and RSU are connected by a special composite cable. The
following configurations are available.
•3 m
•5 m
• 1.5 m
• 2.4 m + connector adapter + 0.6 m
• 4.4 m + connector adapter + 0.6 m
Note: The connector adapter is used when routing the cable through the prober’s
connector panel.
• ALWG function: See Table 4-21.
• Trigger output
Level: TTL
Trigger width: 10 ns
Generated synchronously with ALWG waveform.
•Software
• Instrument library for WGFMU control
• NBTI and general-purpose EasyEXPERT Application Tests
• Sample programs (NBTI and general-purpose measurement using WGFMU
and RTS data analysis)
• WGFMU supported prober vendors
Cascade Microtech
Suss MicroTec
Vector Semicon
Note: The maximum number of installable RSUs for a given prober depends
upon the available space. Please contact your local sales representative for
details on connecting and mounting the WGFMU and RSU.
To Next Page
Loading...
