244 Keysight InfiniiVision 2000 X-Series Oscilloscopes User's Guide
19 Print (Screens)
6 Press the Apply softkey to make the printer connection.
A message appears to tell you whether the connection was successful.
To specify the print options
In the Print Configuration Menu, press the Options softkey to change the following
options:
• Setup Information — Select this to print oscilloscope setup information on your
printout, including vertical, horizontal, trigger, acquisition, math, and display
settings.
• Invert Graticule Colors — Select this to reduce the amount of black ink it takes to
print oscilloscope images by changing the black background to white. Invert
Graticule Colors is the default mode.
• Form Feed — Select this to send a form feed command to the printer after the
waveform is printed and before the setup information is printed. Switch Form
Feed off if you want setup information printed on the same sheet of paper with
the waveform. This option only has an effect when the Setup Information option is
selected. Also, if the amount of setup information will not fit on the same page
with the waveform, it will be printed on a new page regardless of the Form Feed
setting.
• Landscape — Select this to print horizontally on the page instead of vertically
(portrait mode).
To specify the palette option
In the Print Configuration Menu, press the Palette softkey to change the following
options.
raticule Not Inverte
raticule Inverted
To Next Page
Loading...
Need help?
General
