Keysight Technologies N6972A with Option 301

RESistance Subsystem
Resistance commands program the output resistance.
These commands are superseded by [SOURce:]VOLTage:RESistance[:LEVel][:IMMediate][:AMPLitude]
and [SOURce:]VOLTage:RESistance:STATe in later versions of the firmware (refer to Firmware
Updates). The following commands will be accepted, but the new ones are recommended for new
applications.
[SOURce:]RESistance[:LEVel][:IMMediate][:AMPLitude] <value>|MIN|MAX
[SOURce:]RESistance[:LEVel][:IMMediate][:AMPLitude]? [MIN|MAX]
Sets the output resistance level. Units are in ohms. Refer to Set the Output Resistance for the model-
specific resistance programming ranges.
Parameter Typical Return
0 to 6.4 Ω (model dependent) | MIN | MAX
*RST0,
0
Specifies an output resistance of 0.5 ohms: RES 0.5
[SOURce:]RESistance:STATe 0|OFF|1|ON
[SOURce:]RESistance:STATe?
Enables or disables output resistance programming.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0or1
Turns resistance programming on: RES:STAT ON
6 SCPI Programming Reference
255 Keysight N6900/N7900 Series Operating and Service Guide