Keysight Technologies N6972A with Option 301

FETCh Subsystem
Fetch commands return measurement data that has been previously acquired. FETCh queries do not
generate new measurements, but allow additional measurement calculations from the same acquired
data.The data is valid until the next MEASure or INITiate command occurs.
FETCh
[:SCALar]
:CURRent
[:DC]? [<start_index>, <points>] Returns the averaged measurement.
:ACDC? Returns the RMS measurement (AC + DC).
:HIGH? Returns the High level of a pulse waveform.
:LOW? Returns the Low level of a pulse waveform.
:MAXimum? Returns the maximum or minimum value.
:MINimum?
:POWer
[:DC]? Returns the averaged measurement.
:MAXimum? Returns the maximum or minimum value.
:MINimum?
:VOLTage
[:DC]? [<start_index>, <points>] Returns the averaged measurement.
:ACDC? Returns the RMS measurement (AC + DC).
:HIGH? Returns the High level of a pulse waveform.
:LOW? Returns the Low level of a pulse waveform.
:MAXimum? Returns the maximum or minimum value.
:MINimum?
:AHOur? [IGNORE_OVLD] Returns the accumulated amp-hours.
:ARRAY
:CURRent
[:DC]? [<start_index>, <points>] Returns the instantaneous measurement.
:POWer
[:DC]? Returns the instantaneous measurement.
:VOLTage
[:DC]? [<start_index>, <points>] Returns the instantaneous measurement.
:ELOG? <maxrecords> Returns the most recent external datalog records.
:WHOur? [IGNORE_OVLD] Returns the accumulated watt-hours.
Keysight N6900/N7900 Series Operating and Service Guide 226
6 SCPI Programming Reference