:TYPE CURRent|VOLTage Specifies either a voltage or current Arb.
:TERMinate
:LAST 0|OFF|1|ON Selects the output setting after the Arb ends.
:VOLTage
:CDWell
[:LEVel] <value>{,<value>}|<Block> Specifies the level of each point in the Arb.
:DWELl <value> Specifies the dwell time of each point in the Arb.
:POINts? Returns the number of points in the Arb.
[SOURce:]CURRent Subsystem
[SOURce:]
CURRent
[:LEVel]
[:IMMediate]
[:AMPLitude] <value> Sets the output current when in current priority mode
:TRIGgered
[:AMPLitude] <value> Sets the triggered output current
:LIMit
[:POSitive]
[:IMMediate]
[:AMPLitude] <value> Sets the current limit when in voltage priority mode.
:NEGative
[:IMMediate]
[:AMPLitude] <value> Sets the current limit when in voltage priority mode.
:MODE FIXed|STEP|LIST|ARB Sets the transient mode.
:PROTection
:DELay
[:TIME] <value> Sets the over-current protection delay.
:STARt SCHange|CCTRans Specifies what starts the over-current protection delay timer.
:STATe 0|OFF|1|ON Enables or disables the over-current protection.
:SHARing
[:STATe] 0|OFF|1|ON Enables or disables current sharing on paralleled units.
:SLEW
[:IMMediate] <value>|INFinity Sets the current slew rate.
:MAXimum 0|OFF|1|ON Enables or disables the maximum slew rate override.
[SOURce:]DIGital Subsystem
[SOURce:]
DIGital
:INPut
:DATA? Reads the state of the digital control port.
:OUTPut
1 Quick Reference
32 Keysight N6900/N7900 Series Operating and Service Guide
To Next Page
Loading...
