Front Panel Menu Reference
Press the Menu key to access the front panel menus. For a brief tutorial, refer to Use the front panel
menu. If a menu item is grayed-out, it is not available for the model that is being programmed.
1st Menu Level 2nd Level 3rd & 4th Levels Description
Output Voltage Programs output voltage settings
Current Programs output current settings
Mode Programs output priority mode
Sequence Delay Programs output on/off delay
Couple Configures output state coupling
Advanced Slew Programs output current or voltage slew rates
Resistance Programs output resistance
Bandwidth Current Programs current bandwidth
Voltage Programs voltage bandwidth
Tmode Programs output turn-on/turn-off mode
CurrSharing Enables/disables output current sharing
Measure Sweep Configures measurement sampling
Window Selectmeasurement window
Control Initiates, triggers, and aborts acquisitions; displays trig state
AhWh Measures or resets amp-hours and watt hours
Transient Mode Selects voltage and current transient modes
Step Configures voltage or current steps and trigger signals
List Pace Specifies Dwell or Trigger paced list
Repeat Specifies number of list repetitions, or continuous list
Terminate Specifies list termination conditions
Config Configures individual list step settings
Reset Aborts the list and resets all list settings
Arb Repeat Specifies number of Arb repetitions, or continuous Arb
Terminate Specifies Arb termination conditions
Config Configures individual Arb settings
Keysight RP7900 Series Operating and Service Guide 21
1 Quick Reference
To Next Page
Loading...
Need help?
General
