Set the Output Bandwidth - RP795xA, RP796xA 105
Set the Output Bandwidth - RP793xA, RP794xA 106
Set the Output Turn-On/Turn-Off Mode - RP793xA, RP794xA 108
Enable the Output 108
Parallel Operation 110
Introduction 110
Master/Slave Operation 111
Independent Parallel Operation - RP795xA, RP796xA 115
Current Sinking Operation 118
Current Sinking 118
Regenerative Operation 118
Programming Output Protection 119
Introduction 119
Set the Over-Voltage Protection 120
Set the Over-Current Protection 120
Output Watchdog Timer 122
Set the Under-Voltage Protection 122
Clear Output Protection 123
Programming Output Transients 124
Output Transients 124
Common Actions for All Transients 124
Programming a Step Transient 127
Programming a List Transient 128
Programming an Arbitrary Waveform 132
Sequencing the Output 134
Turn-On/Turn-Off Delays 134
Coupling the Output 134
Sequencing Multiple Units 135
Output Turn-On Turn-Off Behavior 137
External Data Logging 141
External Data Logging 141
Select the Measurement Function and Range 142
Specify the Integration Period 142
Select the Elog Trigger Source 142
Initiate and Trigger the Elog 143
Periodically Retrieve the Data 143
Terminate the Elog 144
Making Measurements 145
Average Measurements 145
Measurement Sweep 145
Measurement Windowing 146
A-hour & W-hour measurement 146
Digitized Measurements 147
Measurement Triggering 149
Programming the Digital Port 155
Digital Control Port 155
Bi-Directional Digital I/O 156
Digital Input 157
5 Keysight RP7900 Series Operating and Service Guide
To Next Page
Loading...
Need help?
General
