Keysight 34980A - Page 109

Features and Functions 3
Keysight 34980A Mainframe User’s Guide 109
Auto-IP
The Auto-IP standard automatically assigns an IP address to the 34980A when on
a network that does not have DHCP servers.
If you change the Auto-IP configuration, you must cycle power on the 34980A to
activate the new setting.
– Auto-IP allocates IP addresses from the link-local address range
(169.254.xxx.xxx).
– From the factory, the Auto-IP setting is enabled.
– The Auto-IP setting is stored in non-volatile memory, and does not change
when power has been off, after a Factory Reset (*RST command), or after an
Instrument Preset (SYSTem:PRESet command).
Front Panel Operation:
Utility > REMOTE I/O > LAN > LAN SETTINGS > MODIFY > DHCP OFF >
AUTO IP
Remote Interface Operation:
SYSTem:COMMunicate:LAN:AUTOip (OFF|ON}