Keysight 34980A - Sending SCPI Commands Via the Web Interface

2 Getting Started
92 Keysight 34980A Mainframe User’s Guide
Sending SCPI Commands Via the Web Interface
The Web Interface provides a utility to send SCPI commands to the 34980A via
the SCPI Command Interface window. The procedure below shows how to access
this window and send commands.
1 Press the Commands button at the top of the Web Browser Control page to
launch the SCPI Command Interface window.
2 The SCPI Command Interface window allows you to:
NOTE
You must be in the Allow Full Control mode to send instrument commands to the
34980A.
1