Features and Functions 3
Keysight 34980A Mainframe User’s Guide 133
To clear the channel label on the selected channel, change each character to “ ^ ”
(starting with the rightmost character) and then press the left arrow key to move
to the next character.
To clear all channel labels on the selected module, navigate to:
Module (Configure) > CLEAR LABELS? > YES
Remote Interface Operation:
The following command assigns a label
(“TEST_PT_1”) to channel 3 in slot 1.
ROUT:CHAN:LABEL "TEST_PT_1",(@1003)
The following command clears the user-defined label previously assigned to
channel 3 in slot 1. The channel will now be identified by its factory default label
(e.g., “MUX CH BANK 1”, “MATRIX1 ROW3 COL4”, “DIO BYTE 1”, etc.).
ROUT:CHAN:LABEL "",(@1003)
The following command clears all user-defined channel labels on the module in
slot 1. The factory-default labels are assigned to all channels on the module in
slot 1.
ROUT:CHAN:LABEL:CLEAR:MOD 1
The following command clears all user-defined labels on all modules installed in
the 34980A. The factory-default labels are assigned to all channels on all installed
modules.
ROUT:CHAN:LABEL:CLEAR:MOD ALL
To Next Page
Loading...
