1 Introduction to the 34980A
28 Keysight 34980A Mainframe User’s Guide
– You can also program a time delay between channels in the scan list (see
“Channel Delay” on page 161).
– You can manually control a scan by repeatedly pressing the Scan (Measure)
key from the front panel.
– You can start a scan by sending a software command from the remote
interface (MEASure? or INITiate command).
– You can start a scan when an external TTL trigger pulse is received.
– You can start a scan when an alarm event is logged on the channel being
monitored.
For more information on scanning, see “Scanning” on page 148.
Scan List
t
t
Ch 1 Ch 2
Ch 3 Ch 4
Ch 5
Ch 6
t1
t2
t3
t4
t5
t6
Channel Delay
(0 to 60 seconds)
To Next Page
Loading...
