4Operation
32 Keysight 85024A User’s and Service Guide
Operating Precautions
Electrostatic discharge (ESD), excessive input signals or mechanical shock
can dramatically degrade the performance of the probe. Be sure to observe
the following precautions.
– Never touch the tip of the probe!
– Always hold the probe by the retracted metal sleeve.
– Work at a workstation equipped with an anti-static mat.
– Extend the protective sleeve when not actually taking measurements.
– Wear an anti-static wrist strap and avoid introducing static electricity into
the device under test (DUT) or test setup.
– Make sure the device under test (DUT) is at the same ground potential as
the probe.
To Next Page
Loading...
