Service 7
Keysight 85024A User’s and Service Guide 67
Figure 7-7 Probe wand components
Removing the plastic regulator housing covers
Tools required:
– 1/8 inch-wide flatblade screwdriver
Refer to Figure 7-8.
1 Hold the regulator assembly by one end and insert the head of a 1/8 inch-wide
flatblade screwdriver into the seam at the other end. The seam separates the
two halves of the housing cover. Twist the screwdriver 90°.
Failure to remove the nose assembly prior to replacing the tip will result in
damage to the conductive elastomer on the tip assembly.
In the steps below, hold the regulator housing and screwdriver so that you
won’t injure yourself if the screwdriver slips.
To Next Page
Loading...
