Keysight E8257D/67D - Hardware

E8257D/67D, E8663D PSG Signal Generators Service Guide
Replaceable Parts
Assemblies and Hardware Options
2-35
Hardware
This section lists part numbers for hardware and other instrument parts in your signal generator.
• “Front Panel View” on page 2- 36
• “Disassembled Front Panel View” on page 2- 38
• “Disassembled Rear Panel View” on page 2- 40
• “Disassembled A32 10 MHz Crystal Oscillator (Option UNR/UNX/UNY and Instruments with Serial Prefixes >=
US4805/MY4805)” on page 2- 43
• “Disassembled AT1 90dB/115dB Attenuator View (Option 1E1)” on page 2- 44
• “Disassembled A24 20GHz/40GHz Highband Coupler and A25B Highband Detector Bias Board (Options 503, 509,
520, and 540)” on page 2- 45
• “Disassembled A24 50GHz Highband Coupler and A25B Highband Detector Bias Board” on page 2- 47
• “Disassembled A24 67GHz Highband Coupler and A25B Highband Detector Bias Board” on page 2- 48
• “Microcircuit Interface Deck Top View” on page 2- 49
• “Main Chassis and MID Bottom View” on page 2- 50
• “1.85 mm RF Output Connector (Option 567 Only)” on page 2- 53
• “2.4 mm RF Output Connector” on page 2- 54
• “APC 3.5 RF Output Connector (Option 520 Only)” on page 2- 55
• “Type- N RF Output Connector (Option 1ED Models Only)” on page 2- 56
• “Main Chassis with Inside Cover and Right- Side Support Wall” on page 2- 57
• “Outer and Inner Instrument Covers and Associated Parts” on page 2- 58