E8257D/67D, E8663D PSG Signal Generators Service Guide
Assembly Replacement
A40 Compact Flash Drive Assembly
3-112
A40 Compact Flash Drive Assembly
Tools Required
• T–10 driver
• Standard Screwdriver
Removal Procedure
Refer to Figure 3- 66 and Figure 3- 67 for this procedure.
1. Disconnect the power cord.
2. Remove the covers from the signal generator. Refer to “Outer Instrument Cover” on page 3- 4 and “Inner
Instrument Cover” on page 3- 6.
3. Disconnect the W66 ribbon cable from A18P2.
4. Using the standard screwdriver, unlock the A41 door latch screw by rotating counter–clockwise.
5. Remove the flash card (if applicable).
6. Using the T–10 driver, remove the two upper screws (1) that attach the A40 PCA/CF drive assembly to the rear
panel.
Replacement Procedure
1. Reverse the order of the removal procedure.
2. Torque all T–10 screws to 9 in–lbs.
3. Perform the post–repair adjustments and performance tests that pertain to this removal procedure.
To Next Page
Loading...