Keysight InfiniiVision DSOX1102G User Manual

Quick Reference 2
Keysight InfiniiVision 1000 X-Series Oscilloscopes User's Guide 65
The vertices in a mask file are normalized. There are four parameters that define
how values are normalized:
•X1
• ΔX
•Y1
•Y2
These four parameters are defined in the Oscilloscope Setup portion of the mask
file.
The Y-values (normally voltage) are normalized in the file using the following
equation:
Y
norm
= (Y - Y1)/ΔY
where ΔY = Y2 - Y1
To convert the normalized Y-values in the mask file to voltage:
Y = (Y
norm
* ΔY) + Y1
where ΔY = Y2 - Y1
The X-values (normally time) are normalized in the file using the following
equation:
X
norm
= (X - X1)/ΔX
To convert the normalized X-values to time:
X = (X
norm
* ΔX) + X1
Oscilloscope
Setup Information
The keywords "setup" and "end_setup" (appearing alone on a line) define the
beginning and end of the oscilloscope setup region of the mask file. The
oscilloscope setup information contains remote programming language
commands that the oscilloscope executes when the mask file is loaded.
Any legal remote programming command can be entered in this section.
The mask scaling controls how the normalized vectors are interpreted. This in turn
controls how the mask is drawn on the display. The remote programming
commands that control mask scaling are:
:MTES:SCAL:BIND 0
:MTES:SCAL:X1 -400.000E-06
:MTES:SCAL:XDEL +800.000E-06

Keysight InfiniiVision DSOX1102G Specifications

General

Brand	Keysight
Model	InfiniiVision DSOX1102G
Category	Test Equipment
Language	English