Keysight N6702C - Page 238

[SOURce:]CURRent:SLEW[:POSitive]:MAXimum 0|OFF|1|ON, (@<chanlist>)
[SOURce:]CURRent:SLEW[:POSitive]:MAXimum? (@<chanlist>)
[SOURce:]CURRent:SLEW:NEGative:MAXimum 0|OFF|1|ON, (@<chanlist>)
[SOURce:]CURRent:SLEW:NEGative:MAXimum? (@<chanlist>)
Enables/disables the maximum slew rate override. When enabled, the slew rate is set to its maximum
value. When disabled, the slew rate is set to the immediate value set by CURRent:SLEW. Use
CURRent:SLEW? MAX to query the maximum slew rate.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0or1
Disable the positive maximum slewrate: CURR:SLEW:MAX OFF, (@1)
Disable the negative maximum slewrate: CURR:SLEW:NEG:MAX OFF, (@1)
l The CURRent:SLEW:MAX command is coupled to the CURRent:SLEW command. If the
CURRent:SLEW command sets the slew rate to MAX or INFinity, CURRent:SLEW:MAX is enabled.
If the slew rate is set to any other value, CURRent:SLEW:MAX is disabled.
5 SCPI Programming Reference
238 Keysight N6700C Operating and Service Guide