Front Panel Menu Reference
Press the Menu key to access the front panel menus. For a brief tutorial, refer to Use the Front Panel
Menu. If a menu item is grayed-out, it is not available for the module that is being programmed.
1st Menu Level 2nd Level 3rd & 4th Levels Description
Output Settings Voltage Programs the voltage setting, limits, and ranges
Current Programs the current setting, limits, and ranges
Power Programs the power limiton models N679xA loads
Resistance Programs the resistance setting on N679xA loads
Programs output resistance on N6781A, N6785A
Mode Selects voltage, current, resistance, or power priority modes on
N678xA SMU, N679xA
Sequence Delay Programs Turn-on /Turn-off delay
Couple Couples output channels for output on/off synchronization
Short Programs an input short on models N679xA loads
Advanced
Slew Current
Programs current slew rate on models N678xA SMU, N679xA
Voltage Programs voltage slewrate
Power Programs power slewrateon models N679xA loads
Resistance Programs resistance slewrateon models N679xA loads
Pol Reverses the polarity of the output and sense terminals
Bandwidth Programs output bandwidth on N678xA SMU, N679xA
UVI Configures under-voltage inhibit on N679xA loads
Tmode Programs turn-on/turn-off impedance on N678xA SMU
Measure Range Selects voltage and current measurement range
Sweep Specifies measurement points, time interval, trigger offset
Window Selects measurement window: Rectangular, Hanning
Input Selects Auxiliary voltage input on N6781A, N6785A
Control Lets you abort a measurement in progress
Transient Mode Selects voltage, current, resistance, or power transient modes
Step Specifies the triggered step values
List Pace Specifies Dwell or Trigger paced list
Keysight N6700C Operating and Service Guide 23
1 Quick Reference
To Next Page
Loading...
