When you click the Control Instrument tab, a representation of the front panel appears on the display.
Use your mouse to control the front panel buttons in the same way that you would control the actual
front panel of the instrument.
Using Telnet
In an MS-DOS Command Prompt box type: telnet hostname 5024 where hostname is the instrument's
hostname or IP address, and 5024 is the instrument’s telnet port.
You should get a Telnet session box with a title indicating that you are connected to the power system.
Type the SCPI commands at the prompt.
Keysight N6700C Operating and Service Guide 91
3 Getting Started
To Next Page
Loading...
