Specifications
Supplemental Characteristics
Dimension Diagrams
This section lists the supplemental characteristics of the Keysight N6700C Modular Power System.
Supplemental characteristics are not warranted but are descriptions of performance determined by
design or by type testing. All supplemental characteristics are typical unless otherwise noted.
Specifications and characteristics are subject to change without notice.
Complete specifications and supplemental characteristics information for all power
modules are included in the Keysight N6700 Modular Power System Family
Specifications Guide.
Supplemental Characteristics N6700C, N6701C, N6702C
Characteristic Keysight N6700C, N6701C, N6702C
Maximum Total Power Available for Power
Modules:
400 W(for N6700C mainframes)
600 W(for N6701C mainframes)
1200 W (for N6702C mainframes)
Internal Flash memory: 8 Mbytes
Protection Response
INH Input:
Fault on coupled output:
5 µs from receipt of inhibitto start of shutdown
< 10 µs from receipt of fault to start of shutdown
Command Processing Time: ≤ 1 ms from receipt of command to start of output change
Digital Control Characteristics
Maximum voltage ratings
Pins 1 and 2 as FLT output
Pins 1 - 7 as digital/trigger outputs
(pin 8 = common)
Pins 1 - 7 as digital/trigger inputs and pin
3 as INH input (pin 8 = common)
+16.5 VDC/-5 VDC between pins
(pin 8 is internally connected to chassis ground).
Maximum low-level output voltage = 0.5 V @ 4 mA
Maximum low-level sink current = 4 mA
Typical high-level leakage current = 1 mA @ 16.5 VDC
Maximum low-level output voltage = 0.5 V @ 4 mA;
1 V @ 50 mA; 1.75 V @ 100 mA
Maximum low-level sink current = 100 mA
Typical high-level leakage current = 0.8 mA @ 16.5 VDC
Maximum low-level input voltage = 0.8 V
Minimum high-level input voltage = 2 V
Typical low-level current = 2 mA @ 0 V (internal 2.2k pull-up)
Typical high-level leakage current = 0.12 mA @ 16.5 VDC
Keysight N6700C Operating and Service Guide 45
1 Quick Reference
To Next Page
Loading...
