Keysight N6702C - Fetch Commands

Fetch Commands
Fetch commands return measurement data that has been previously acquired by a MEASurement
command or triggered acquisition. FETCh queries do not generate a new measurement, but allow
additional measurement calculations from the same acquired data.The data is valid until the next
MEASure or INITiate command occurs.
FETCh commands require to be installed on models N673xA. N674xA,
N675xA, and N677xA.
FETCh[:SCALar]:CURRent[:DC]? (@<chanlist>)
FETCh[:SCALar]:VOLTage[:DC]? (@<chanlist>)
FETCh[:SCALar]:POWer[:DC]? (@<chanlist>)
Returns the averaged measurement. Values returned are either in amperes, volts, or watts. The
reading is in the form +n.nnnnnnE+nn for each channel specified. Multiple responses are separated by
commas.
Parameter Typical Return
(none) <DC value>
Returns the averaged current FETC:CURR? (@1)
Returns the averaged voltage FETC:VOLT? (@1)
Returns the averaged power FETC:POW? (@1)
FETCh[:SCALar]:CURRent:ACDC? (@<chanlist>)
FETCh[:SCALar]:VOLTage:ACDC? (@<chanlist>)
Returns the RMS measurement (AC + DC). Values returned are either in amperes, or volts. See
Measurement Types. The reading is in the form +n.nnnnnnE+nn for each channel specified. Multiple
responses are separated by commas.
Parameter Typical Return
(none) <ACDC value>
Returns the measured RMS current FETC:CURR:ACDC? (@1)
Returns the measured RMS voltage FETC:VOLT:ACDC? (@1)
FETCh[:SCALar]:CURRent:HIGH? (@<chanlist>)
FETCh[:SCALar]:VOLTage:HIGH? (@<chanlist>)
Returns the High level of a pulse waveform. Values returned are either in amperes, or volts. See
Measurement Types. The reading is in the form +n.nnnnnnE+nn for each channel specified. Multiple
responses are separated by commas.
5 SCPI Programming Reference
242 Keysight N6700C Operating and Service Guide