Keysight N6702C - Page 32

:AUTO 0|OFF|1|ON, (@chanlist) Enables/disables seamless measurement autoranging. (N678xA SMU)
:WINDow (WINDow command only on N676xA, N678xA SMU, Option 054)
[:TYPE] HANNing|RECTangular, (@chanlist) Selects the measurement window.
[SOURce:]
ARB (ARB commands only on N676xA, N678xA SMU, Option 054)
:COUNt? Sets the ARB repeat count.
:CURRent | :VOLTage | :POWer | :RESISTANCE Sets the Arb type (POWer and RESISTANCE only on N679xA)
:CDWell
[:LEVel] <value>, {<value>}, (@chanlist) Sets the list of the constant dwell Arb
:DWELl <value>, (@chanlist) Sets the dwell time for the constant dwell Arb
:POINts? (@chanlist) Returns the number of constant-dwell Arb points
:CONVert (@chanlist) Converts the selected Arb to a user-defined list
:EXPonential
:END
[:LEVel] <value>, (@chanlist) Sets the end level of the exponential Arb
:STARt
[:LEVel] <value>, (@chanlist) Sets the initial level of the exponential Arb
:TIMe <value>, (@chanlist) Sets the length of the start time or delay
:TCONstant <value>, (@chanlist) Sets the time constant of the exponential Arb
:TIMe <value>, (@chanlist) Sets the time of the exponential Arb
:PULSe
:END
:TIMe <value>, (@chanlist) Sets the length of the end time
:STARt
[:LEVel] <value>, (@chanlist) Sets the initial level of the pulse
:TIMe <value>, (@chanlist) Sets the length of the start time or delay
:TOP
[:LEVel] <value>, (@chanlist) Sets the top level of the pulse
:TIMe <value>, (@chanlist) Sets the length of the pulse
:RAMP
:END
[:LEVel] <value>, (@chanlist) Sets the end level of the ramp
:TIMe <value>, (@chanlist) Sets the length of the end time
:RTIMe <value>, (@chanlist) Sets the rise time of the ramp
:STARt
[:LEVel] <value>, (@chanlist) Sets the initial level of the ramp
:TIMe <value>, (@chanlist) Sets the length of the start time or delay
:SINusoid
:AMPLitude <value>, (@chanlist) Sets the amplitude of the sine wave
:FREQuency <value>, (@chanlist) Sets the frequency of the sine wave
:OFFSet <value>, (@chanlist) Sets the DC offset of the sine wave
:STAIRcase
1 Quick Reference
32 Keysight N6700C Operating and Service Guide