l Primary Address - This field enters the primary address of the server. Contact your LAN admin-
istrator for server details. The same numbering notation applies as for the IP Address. A value of
0.0.0.0 indicates that no default server is defined.
l Secondary Address - This field enters the secondary address of the server. Contact your LAN
administrator for server details. The same numbering notation applies as for the IP Address. A
value of 0.0.0.0 indicates that no default server is defined.
Dot-notation addresses ("nnn.nnn.nnn.nnn" where "nnn" is a byte value from 0 to 255) must be
expressed with care, as most PC web software interprets byte values with leading zeros as octal
(base 8) numbers. For example, "192.168.020.011" is actually equivalent to decimal "192.168.16.9"
because ".020" is interpreted as "16" expressed in octal, and ".011" as "9". To avoid confusion, use only
decimal values from 0 to 255, with no leading zeros.
mDNS Service Name
The mDNS service name is registered with the selected naming service. To configure the mDNS
service name of the instrument:
Front Panel Menu Reference SCPI Command
Select System\IO\LAN\Modify\Name
You can enter any value from the numeric keypad. For additional
characters, use the up/down navigation keys to enter an alpha
character by scrolling through the selection list that appears
when you press the keys. Use the left/right navigation keys to
traverse the text field. Use the backspacekey to delete a value.
Press Enter when you are finished.
Not available
l mDNS Service Name - This field registers the service name with the selected naming service. If
the field is left blank, no name is registered. A service name may contain upper and lower case let-
ters, numbers and dashes(-).
Each power system is shipped with a default service name with the format: Keysight-mod-
elnumber-serialnumber, where modelnumber is the mainframe’s 6-character model number (e.g.
N6700C), and serialnumber is the last five characters of the 10-character mainframe serial num-
ber located on the label on the top of the unit (e.g. 45678 if the serial number is MY12345678).
Services
This selects the LAN services to enable or disable.
Front Panel Menu Reference SCPI Command
Select System\IO\LAN\Modify\Services
Check or uncheck the services that you wish to enable or disable
Not available
Keysight N6700C Operating and Service Guide 89
3 Getting Started
To Next Page
Loading...
