EasyManuals Logo

Keysight N777 C Series User Manual

Keysight N777 C Series
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
94 Keysight N777-C Series Tunable Laser Family User’s Guide
5 N777-C Instrument’s Front Panel Display
These are the parameters for the wavelength sweep:
Sweep Mode - see How to Perform a Sweep? on page 96,
Repeat Mode - see How to Set the Repeat Mode? on page 95,
Sweep Speed - the speed of a continuous sweep,
Cycles - the number of times the sweep is repeated,
Dwell - the amount of time spent at the wavelength during each step,
for a stepped sweep
Sweep Start - the wavelength at which the sweep begins,
Sweep Stop - the wavelength at which the sweep ends,
Sweep Step - the size of the change in the wavelength for each step of
a sweep,
Run/Stop Sweep - to run and start the sweep.
NOTE
For a Continuous sweep, Step sets the wavelength interval between
output triggers, if you have set Output Trigger Mode to Step Finished,
see
How to Use Output Triggering on page 99.

Table of Contents

Other manuals for Keysight N777 C Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight N777 C Series and is the answer not in the manual?

Keysight N777 C Series Specifications

General IconGeneral
BrandKeysight
ModelN777 C Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals