Keysight N9322C - Page 100

Command Reference
Calculate Subsystem
92
Limit Beep State
:CALCulate:LLINe:CONTrol:BEEP OFF|ON|0|1
:CALCulate:LLINe:CONTrol:BEEP?
Use this command to turn on/off the limit beep status.
Example: :CALCulate:LLINe:CONTrol:BEEP ON
Key access: Shift > Limit > X Axis Units
Define Limits Values
:CALCulate:LLINe[1]|2:DATA
<x-axis>,<ampl>,<connected>{,<x-axis>,<ampl>,<co
nnected>}
:CALCulate:LLINe[1]|2:DATA?
Use this command to define the limits values.
Example: :CALC:LLIN1:DATA 10000000,-20,0,20000000,-30,1
Key access: Shift > Limit > Limit 1 > Edit Limits
Delete Limits Values
:CALCulate:LLINe[1]|2:DELete
Use this command to delete the limits values.
Example: :CALCulate:LLINe:DELete
Delete All Limits Data
:CALCulate:LLINe:ALL:DELete
Use this command to define all the limits values.
Example: :CALCulate:LLINe:ALL:DELete
Query Limits Result
:CALCulate:LLINe[1]|2:FAIL?
Use this command to query the limit result.
Example: :CALCulate:LLINe1:FAIL?