Command Reference
Reflection Measurement Option Subsystem
138
Reflection Measurement Distance Unit
[:SENSe]:CAT:DISTance:UNIT METers|FEET
[:SENSe]:CAT:DISTance:UNIT?
Use this command to toggle the distance unit between meter
and feet.
Example: :CAT:DISTance:UNIT FEET
Key access: Meas > Unit > Meter/Feet
Reflection Measurement DTF Frequency Domain State
[:SENSe]:CAT:DTF:FVIew OFF|ON|0|1
[:SENSe]:CAT:DTF:FVIew?
Use this command to turn on/off frequency domain display
in distance to fault measurement mode.
Example: :CAT:DTF:FVIew ON
Key access: Meas > Freq Domain
Reflection Measurement Amplitude Auto Scale
CAT:SCALe:AUTO
Use this command to perform amplitude auto scale once.
Example: :CAT:SCALe:AUTO
Key access: Amptd > Auto Scale
Reflection Measurement Amplitude Scale Reference Level
[:SENSe]:CAT:SCALe:REFerence <value>
[:SENSe]:CAT:SCALe:REFerence?
This command defines the amplitude scale reference level.
Range: 0 to 60
Example: :CAT:SCALe:REFerence 12
Key access: Amptd > Ref Level
To Next Page
Loading...
