201
Command Reference
Power Meter Option Subsystem
Power Meter Reference Power State
[:SENSe]:CORRection:CSET1:STATe OFF|ON|0|1
[:SENSe]:CORRection:CSET1:STATe?
Use this command to turn on/off reference power state.
Example: :CORRection:CSET1:STATe 1
Key access: Meas > General Setup > Rel/Offset > Rel > On/Off
Set Power Meter Reference Power Value
[:SENSe]:CORRection:CSET1[:INPut][:MAGNitude]
<value>
[:SENSe]:CORRection:CSET1[:INPut][:MAGNitude]?
This command defines the reference power value.
Example: –200 to +200 dBm
Example: :CORRection:CSET1:INPut:MAGNitude 10dBm
Key access: Meas > General Setup > Rel/Offset > Rel
Set Power Meter Offset State
[:SENSe]:CORRection:GAIN2:STATe OFF|ON|0|1
[:SENSe]:CORRection:GAIN2:STATe?
This command turns on/off offset state for power meter
measurement.
Example: :CORRection:GAIN2:STATe 1
Key access: Meas > General Setup > Rel/Offset > Offset
Set Power Meter Offset Value
[:SENSe]:CORRection:GAIN2[:INPut][:MAGNitude]
<value>
[:SENSe]:CORRection:GAIN2[:INPut][:MAGNitude]?
This command defines the offset value of power meter
measurement.
Example: :CORRection:GAIN2:INPut:MAGNitude 15
Key access: Meas > General Setup > Rel/Offset > Offset
To Next Page
Loading...
Need help?
General
