Chapter 1 9
Preparing for Calibration and Performance Verification Test
Recommended Test Equipment
Table 1-3 Recommended Torque Settings
Type Description
Precision
7mm
12 lb-in (136 N-cm.)
Precision
3.5mm
8 lb-in (90 N-cm)
SMA 5 lb-in (56 N-cm) Use the SMA wrench to connect male
SMA connectors to female precision 3.5min connectors.
Connections of male precision 3.5mm. connectors to female
SMA connectors can be made with the precision 3.5mm
torque wrench (8 lb-in).
Type-N Type-N connectors may be connected finger tight. If a
torque wrench is used, 12 lb-in (136 N-cm) is
recommended.
To Next Page
Loading...
