Keysight U1271A - Making Scale Transfers (Scale); Table 3-1 Available Scale Conversions; Scale Transfer Enabled

3Multimeter Features
Making Scale Transfers (Scale)
110 U1271A/U1272A User’s Guide
Making Scale Transfers (Scale)
The Scale operation emulates a transducer by helping you to
convert the measured readings proportionally to the
specified ratio and unit display. Use Scale to transfer voltage
readings to proportional readings when using clamp- on
current probes or high voltage probes. The available scale
conversions are shown in the table below.
1 Press and hold for more than 1 second to enable
the Scale operation.
2 The most recently saved (default: 1 kV/V, ×1000.0) ratio
and unit will be shown on the primary and secondary
displays. Press while the symbol is flashing
to cycle through the available ratio and unit displays.
3 Press while the symbol is flashing to save
the selected ratio and unit and start the conversion. The
selected ratio and unit will be used as the default ratio
and unit the next time Scale is enabled.
4 Or, while the symbol is flashing, if no activity is
detected after 3 seconds, the conversion will begin (with
the specified ratio and unit shown on the primary
display).
5 Press and hold for more than 1 second to cancel
the Scale operation.
Table 3-1 Available scale conversions
Scale conversion Multiplier
[1]
[1] The transfer formula used is: Display = Multiplier × Measurement
Unit Related units
1 kV/V
[2]
[2] This value and unit can be adjusted from the multimeter’s Setup. See “Changing
the user scale conversion value and unit” on page 149 for more information.
1000 V/V 1000.0 V V, kV
1 A/mV 1000 A/V 1000.0 A A, kA
1 A/10 mV 100A/V 100.0 A A, kA
1 A/100 mV 10 A/V 10.0 A mA, A, kA
S
c
a
l
e
N
u
l
l
S
c
a
l
e
N
u
l
l
H
z
%
m
s
L
o
g
S
c
a
l
e
N
u
l
l