1 Introduction
Preparing Your Multimeter
30 U1271A/U1272A User’s Guide
Adjusting the tilt stand
To adjust the multimeter to a 60° standing position, pull the
tilt- stand outward to its maximum reach.
Figure 1-4 Tilt-stand adjustment and IR cable connection
Connecting the IR-USB cable
You can use the IR communication link (IR communication
port, located at the rear panel) and the Keysight GUI Data
Logger software to control your multimeter remotely,
perform data logging operations, and transfer the contents of
your multimeter’s memory to a PC.
Ensure that the Keysight logo on the U1173A IR- USB cable
(purchased separately) connected to the multimeter is facing
up. Firmly push the IR head into the multimeter’s IR
communication port until it snaps into place (see
Figure 1- 4).
To PC (host)
IR-USB cable
Pull until maximum reach
To Next Page
Loading...
