Keysight U1271A - Changing the Minimum Measurable Frequency; Figure 4-13 Freq Display

Multimeter Setup Options 4
Setup Menu Items
U1271A/U1272A User’s Guide 143
Changing the minimum measurable frequency
This setting is used with frequency tests (see page 101).
Changing the minimum measurable frequency will influence
the measurement rates for frequency, duty cycle, and pulse
width measurements. The typical measurement rate as
defined in the specification is based on a minimum
measurable frequency of 10 Hz.
To change the minimum measurable frequency:
1 Press for more than 1 second to enter the
multimeter’s setup menu.
2 Press or until is shown on the
secondary display.
Figure 4-13 FrEq display
3 Press or to change the frequency value.
4 Press to save your changes or press to
discard your changes.
5 Press and hold until the multimeter restarts to return
to normal operation.
Parameter Range Default setting
FrEq 0.5 Hz or 10 Hz 0.5 Hz
Setup
P
e
a
k
M
a
x
M
i
n
A
u
t
o
R
a
n
g
e
Exit
Dual
Setup
H
z
%
m
s
L
o
g
S
h
i
f
t
V
i
e
w
E
s
c
Setup