Keysight U1271A - Performing Interval Logs (Auto)

3Multimeter Features
Recording Measurement Data (Data Logging)
118 U1271A/U1272A User’s Guide
The maximum number of readings that can be stored for the
manual log is 100 entries. When all entries are occupied,
will be shown when is pressed.
See the “Reviewing Previously Recorded Data (View)” section
later in this manual to review or erase the recorded entries.
Performing interval logs (AUto)
Ensure that is selected as the data logging option in
the multimeter’s Setup.
Set the recording interval duration
1 Press for more than 1 second to enter the
multimeter’s Setup mode.
2 Press until is shown on the secondary
display. Press or to change the duration or a
recording interval from 1 to 99999 seconds (default 1
second).
3 Press to save the changes. Press and hold until
the multimeter restarts.
The duration set in the steps above will determine how long
each recording interval takes. The input signal value at the
end of each interval will be recorded and saved into the
multimeter’s memory.
Start the interval log mode
1 Press for more than 1 second to start interval log
mode.
and the log entry number are displayed at the top
of the display. Subsequent readings are automatically
recorded into the multimeter’s memory at the interval
specified in the Setup mode.
H
z
%
m
s
L
o
g
Setup
A
u
t
o
R
a
n
g
e
Setup
Exit
Dual
H
z
%
m
s
L
o
g
Setup
H
z
%
m
s
L
o
g