Keysight U1271A - Figure 3-6 Manual Log Display; Performing Manual Logs (Hand)

Multimeter Features 3
Recording Measurement Data (Data Logging)
U1271A/U1272A User’s Guide 117
Select the data logging option
1 Press for more than 1 second to enter the
multimeter’s Setup mode.
2 Press until is shown on the secondary
display. Press or to change the data logging
option.
Available options: , , or .
3 Press to save the changes. Press and hold until
the multimeter restarts.
Performing manual logs (HAnd)
Ensure that is selected as the data logging option in
the multimeter’s Setup.
1 Press for more than 1 second to store the present
input signal value.
and the log entry number are displayed at the top
of the display. The display will return to normal after a
short while (around 1 s).
Figure 3-6 Manual log display
2 Repeat step 1 again to save the next input signal value.
Setup
A
u
t
o
R
a
n
g
e
Setup
Exit
Dual
H
z
%
m
s
L
o
g
Setup
H
z
%
m
s
L
o
g