Keysight x-series - Page 14

14 X-Series EMI Receiver Getting Started Guide
Quick Start
Turning on the EMI Receiver the First Time
7. Verify the installation a. On the instrument, press
System, Show
System.
b. Verify that the
purchased
application(s) appear in
the list or have an
entitlement certificate.
If you require further assistance, contact the Keysight
support team.
Online assistance: http://www.keysight.com/find/assist
8. View a signal a. Press the plus
tab.
b. Select
Spectrum Analyzer,
OK.
c. Press
Input/Output,
RF Calibrator, 50
MHz.
d. Press
FREQ, Center
Freq
, 50, MHz.
e. Press
SPAN, 50, MHz.
This routes the internal 50 MHz signal to the
instrument’s input.
Steps Actions Notes