1-3 April 2003
PEGAsys™ LV
76-100016-002
1-2.6.1 SMARTONE IONIZATION DETECTOR
The SmartOne Ionization smoke detector provides true dis-
tributed-intelligence, addressable microprocessor-based
smoke detection to the PEGAsys LV system.
1-2.6.2 SMARTONE PHOTOELECTRIC
DETECTOR
The SmartOne Photoelectric smoke detector provides true
distributed-intelligence, addressable microprocessor-
based smoke detection to the PEGAsys LV system.
1-2.6.3 SMARTONE HEAT DETECTOR
The SmartOne Thermistor heat detector provides true dis-
tributed-intelligence, addressable, microprocessor-based
heat detection to the PEGAsys LV system.
1-2.7
SmartOne Detector Bases
The SmartOne series of detection devices all use univer-
sal mounting bases which are available in two styles:
1. The 4SB is a European-Style 4-inch base which has
an outside diameter that matches that of the low pro-
file SmartOne detectors, which, when combined, cre-
ates a very attractive unit. The 4SB, shown in Figure
1-8, mounts to standard 3-, 3.5-inch, or 100-mm elec-
trical boxes with ease.
Figure 1-8. 4-inch Detector Base
2. The 6SB model, shown in Figure 1-9, is a traditional
style detector base with an integral trim ring which pro-
vides coverage for any inconsistencies between the
electrical box and ceiling material. The 6SB mounts to
standard 3-, 3.5- and 4-inch electrical boxes with ease.
Figure 1-9. 6-inch Detector Base
1-2.8
Addressable Contact Input Device
The SmartOne Contact Monitor (P/N 70-407008-00X) al-
lows an installer the ability to interface typical NO/NC fire
alarm devices (i.e., water flow and tamper switches) to the
PEGAsys LV system. The contact monitor is also used to
interface to the manual alarm stations.
Figure 1-10. Addressable Contact Input Device
1-2.9
Addressable Relay Output Device
The addressable relay output device (P/N 70-408004-001)
provides the PEGAsys LV system with a Form C dry-con-
tact interface for remote control applications.
Figure 1-11. Addressable Relay Output Device
1-2.10 Model DH-2000 Air Duct Housing
The DH-2000 air duct housing is designed for detecting
particles of combustion products in air-handling systems.
Figure 1-12. Air Duct Housing