Kidde Fire Systems PEGAsys

A-2August 1999 76-100016-001
PEGAsys
Intelligent Suppression Control/Fire Alarm System
A-2 SYSTEM STANDBY POWER REQUIREMENTS
The control panel provides regulated power for operating external devices, system operation, and standby battery charging. The
power for operating external devices is expandable. When using additional main power supplies in expansion cabinets, each supply
must be evaluated for its loading in the same way as the primary power supply in the main cabinet.
NOTE: Use Table A3 (Standby or non-alarm) to determine main system power supply and any installed auxiliary power module
standby current requirements.
Table A-3: Standby Power Requirements (24 VDC)
eciveD/eludoM
ybdnatS
)spmA(tnerruC
/eludoM
metsyS
mumixaM
ybdnatS
)spmA(tnerruC
eludoMlortnoClartneC070.0X1= 070.0
eludomXTXR530.0X =
rotinoMylppusrewoP060.0X =
eeS(A5.1xaM,1tuptuOyrailixuA
)2&1setoN
X=
eeS(A5.1xaM,2tuptuOyrailixuA
)2&1setoN
X=
draoBrehtoMpooL-itluM530.0X =
eludoMtuptuOelbiduAlangiS520.0X =
eludoMtuptuOyaleR010.0X =
eludoMtuptuOeiTytiC030.0X =
eludoMtuptuOesaeleRtnegA560.0X =
SECIVEDDLEIFX=
rotceteDnoitazinoI004000.0X =
rotceteDcirtceleotohP504000.0X =
tupnItcatnoCelbasserddA013000.0X =
tuptuOtcatnoCelbasserddA033000.0X =
srotalosIpooL100.0X =
rofnmuloCmuS
daoLybdnatS
)2setoN(
= spmA
NOTE: 1. Auxiliary Outputs and each must be considered for total standby alarm loading of the system power supply.
2. Use of auxiliary 24 VDC outputs of during standby operation must not cause the calculated standby current of the
system to exceed its rated maximum as defined in the Table A-6.