7. If the tractor must be lifted for
servicing, take it to a suitably
equipped workshop.
8. Carry out the following operations
before any operation about the
tractor: Engage the four-wheel
drive, the first gear and the park-
ing brake and put chocks to the
wheels touching the ground.
9. Before lifting the tractor, apply
wooden wedges to the front axle
to avoid it's swinging.
M55O114a M55O115a
10. Use jack lifts of suitable capacity
and apply them at the center of the
front and rear axles while paying
due attention to weight distribution.
14. No decals for the lifting point are
applied on the tractor, as they
would be too difficult to apply in
the available spaces and would be
easily removed or defaced during
normal operation of the tractor.
Apply the jack lift to the lifting
points according to the type of
operation and follow the safety
procedures given before.
•
NOTE
T66O127a
15. When working with your trac-
tors electrical components you
must rst disconnect the battery
cables.
16. TO E N S U R E T HAT T H E R E
ARE NO ACCIDENTS FROM
SPARKS YOU MUST FI RST
DISCONNECT THE NEGATIVE
BATTERY CABLE.
To Next Page
Loading...
Need help?
General
