User Manual
This function achieves voice encryption to ensure secret communication. Scrambled signals can be received and
sent only after enabling this function. This function needs to be set using the programming software.
To transmit signals correctly between a sending radio and a receiving radio via a channel with scrambling
enabled, this function needs to be enabled on the both radios.
The power cord is
disconnected.
Low, interrupted
or no volume
while receiving
signals
The antenna is loose or
installed improperly.
Power off the radio and install the antenna
again.
The speaker is blocked or
damaged.
Clean the outside of the radio. If the problem
remains, contact your dealer or a maintenance
provider the Company authorizes for
examination and repair.
Cannot talk to
group members
under digital
mode
The frequency or signaling is
different from that of other
members
Set the same frequency or signaling for all the
members.
A digital or analogue channel
is set improperly.
Set the same digital or analogue channel for
all the members.
To Next Page
Loading...
