KLR 950 - Page 21

KLR.950 Revision: 2023-10-06
Serial numbers: 3008 – beyond
KLR.00001 – beyond
20
5.5.3: Position correction distance
This parameter tells the height the receiving clip needs to be. Basically, the clip’s opening needs to be
aligned in the middle of both upper and lower belts.
5.6.4: Printing overtravel
When needed, the machine can use the printing overtravel to extend a certain number of pulses of the
feeder motor to make sure to print the full length of the clip. Usually set to 0 because it can be fix simply
by adjusting the ink jet head.
Note:
Multiple pieces have been removed to clarif
y the image
Clips sensor
Receiving position
Flow
Breakoff mechanism
Flow
+
-
Note:
Multiple pieces have been removed to clarify the image