SECTION 2
INSTALLATION
July 2003
2-4
05130661
Cutting water released in the pump is discharged from the drain port and must
be piped to an appropriate location (i.e. sewer line). Piping must meet national
and local piping codes.
Compressed Air:
The facility air connection to the SL-IV Pump should provide clean, dry air at
5.9 bar (85 psig). Air usage is minimal, that is, far less than 1 SCFM.
Rear of Waterjet Pump
A HP Water "OUT"
B Plant Air "IN"
C Cooling Water "IN"
D Cooling Water "OUT
E " Cutting Water "IN"
F Drain
To Next Page
Loading...
