10.1.7. If your loader is equipped with Comfort Drive,
Lower the loader to ground.
Turn on Comfort Drive, if equipped
Apply the parking brake securely
Shut off the engine
Turn on tractor switch so Comfort Drive Solenoid is energized.
Release all hydraulic pressure in all circuits by moving hydraulic control lever or levers in all positions.
Return lever or levers to neutral position.
Turn off tractor switch and remove the key.
then disconnect Comfort Drive electrical disconnect located on RH side of tractor in area of
Mid Mount Coupler Kit or Mid Mount Faster Coupler Kit.
10.1.8. Retract tilt cylinders (A) to roll bucket back and
retract lift cylinders (B) to lower loader boom down
until parking stands make firm contact with ground.
NOTE: Driving the tractor forward slowly while
positioning loader will allow parking stands to
contact ground firmly.
Bucket resting on ground.
Parking Stands
contacting ground firmly.
10.1.9. Retract lift cylinders (C) until bearing box pins
(D) rotates out of bracket towers.
To Next Page
Loading...