A-61316 September 2004 1-9
Turning the power on
and off
Following are illustrations and procedures of turning the power on and off
of the scanner, the video laser printer.
To turn the power on:
• Press the Power switch of the scanner and printer to the On (I) position.
2400DSV-E Scanner Video Laser Printer
When the scanner is turned on, the Control Panel displays a blinking “1”.
When the scanner is ready, the “1” stops blinking.
NOTE: If you load the film in the film carrier and press the Start button
while the printer is warming up, you can scan and memorize the
film image of about 9 pages (Letter or A4 size/400dpi). The Printer
allows that print process to be started as soon as the printer
completes warming up.
Darker
Auto
Lighter
Both ends of Exposure Display blink. If you want the Print
Reserve/Memory Function disabled, contact your Kodak Service
Representative.
To turn the power off:
• Press the Power switch of the scanner and printer to the O (Off)
position.
NOTE: The power to the scanner and printer can be turned On and Off at
the same time by using a cord that is equipped with an on/off
switch saving both time and energy. Make sure that all cords used
comply with the specified ratings of the unit.
To Next Page
Loading...
