A-61316 September 2004 3-7
Selecting the image
density
The Exposure Adjustment keys (Darker and Lighter keys) on the Control
Panel are used to adjust the density of the image to be printed during the
Auto or Manual Exposure mode.
• Darker: makes the image density darker.
• Lighter: makes the image density lighter.
The Auto key on the Control Panel is used to select between Auto or
Manual Exposure mode. When the scanner is in Auto mode, the green
Auto light is on. The green Auto light turns off when the scanner is in the
Manual Exposure mode.
Darker
Auto
Lighter
The bar on the right side of the Darker, Auto, and Lighter keys is the
Exposure Display. This display indicates the current density level of the
printed image.
Using Auto exposure
1. Press the Auto key to select the Auto Exposure mode. The Auto
Exposure indicator will illuminate (green) when Auto Exposure is
selected.
Darker
Auto
Lighter
2. Press the Darker or Lighter key to set the desired image density or
exposure level.
NOTE: When the Darker and Lighter keys are pressed at the same
time, the exposure level returns to the center.
To Next Page
Loading...
