A-61316 September 2004 3-3
Installing a projection
lens
To install a lens with a magnification different from the pre-installed lens:
1. Grasp the Prism Holder lever and pull it up.
2. Pull out the lens unit.
3. Slide the lens unit into the machine along the lens guide.
4. Pull out the Brightness Select lever and slide it to a position
appropriate for the type of the Projection Lens loaded in the machine.
The lever should click into position. (Each lens is color-coded.)
NOTE: Brightness on the screen may be uneven if the Brightness Select
lever is not placed in a position corresponding to the type of the
Projection Lens being used. Be sure to place the lever into the
correct position according to the type of Projection Lens.
To Next Page
Loading...
