A-61316 September 2004 3-19
Setting and recalling
Job Programs
The current setting can be set up to 3 program registration locations (1J,
2J and 3J) for both the Printer connection and the PC connection. Once
the Job Programs have been set you can recall them as needed.
The Memory Input key allows you to store one of the following functions
into memory:
• Negative or positive
• Print mode
• Output format
• Print image density
• Exposure mode
• Centering or Fit
• Masking
• Auto Skew Correction
• Horizontal Area setting
• Vertical Area setting
• Electrical Zoom
• Resolution
• Image Distortion
To set a job program:
1. Press the desired function on the Control Panel (i.e. Resolution, Print
Mode, etc.)
2. Using the head of a pen or pencil, press the Memory Input key. 1J
will blink.
NOTE: To change the program registration location, press the Multi-Print
key. The display rotates in the order of 1J to 2J to 3J to 1J.
3. Select the program registration location (1J, 2J or 3J) and press the
Memory Input key again. When the program registration is complete,
all LEDs on the Control Panel will light up and the normal display is
resumed.
Memory Input key
To Next Page
Loading...
