A-61316 September 2004 3-1
3 Using the Scanner
This chapter provides procedures on how to use the Kodak 2400DSV-E
Scanner.
Following is an outline of the basic printing procedure. Detailed
procedures on these steps can be found later in this chapter.
1. Load the film. The procedure for loading film is determined by the type
of Film Carrier (optional) that is being used. Review the Operator’s
Manual that came with your Film Carrier for more information.
2. Select and replace the lens.
3. Select the connection mode.
4. If desired, zoom, focus or rotate the image.
5. Select negative or positive printing.
6. Select the image density.
7. Enter the number of prints to be made.
8. Select the output format.
9. Adjust the image processing features.
10. Print and scan the displayed image. The printing or scanning of the
image appearing on the screen is initiated after the Start key is
pressed.
To Next Page
Loading...
